MIL-DTL-13931J
International Organization (ISO) for Standardization
ISO 9002
-
Quality Systems Models For Quality Assurance in production, installation
and service
ISO 10012-1
-
Quality Assurance Requirements For Measuring Equipment Part 1:
Metrological Confirmation System for Measuring Equipment
(Application for copies should be addressed to the American National Standards Institute (ANSI), 11
West 42nd Street, New York, NY 10036. DoD activities may obtain copies from Standardization
Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094. )
Society of Automotive Engineers (SAE)
SAE J1122
-
Helical Springs: Specification Check Lists
(Application for copies should be addressed to the Society of Automotive Engineers (SAE), 400
Commonwealth Drive, Warrendale, PA 15096. DoD activities may obtain copies from Standardization
Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094. )
(Non-government standards and other publications are normally available from the organizations that
prepare or distribute the documents. These documents also may be available in or through libraries or
other informational services).
2.4 Order of precedence. In the event of a conflict between the text of this document and the references
cited herein, the text of this document takes precedence. Nothing in this document, however, supersedes
applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 General requirements. The individual item requirements shall be in accordance with the applicable
contract, drawings, and specifications. Any conflicts are to be resolved by means of the order of
precedence (see 2.4). Any items the contractor considers ambiguous shall be clarified with the Procuring
Contracting Officer.
3.2 Material. When a drawing permits a choice of type, form, grade, condition or other classification of
materials, the finished part shall comply with the individual cannon specification and this specification, as
well as the applicable drawing.
3.2.1 Material, Steel. Wrought standard steels selected must conform to a standard Society of
Automotive Engineers (SAE) or American Iron and Steel Institute (AISI) steel of the plain carbon or low
alloy classification. Merchant quality, leaded and free-cutting (re-sulfurized or re-phosphorized or both)
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business